bafonso 8/4/2018 1:05 PM
Yamaha SA2000 rewiring required?
Hey everyone, the electronics on my vintage sa2000 were starting to fail and I decided to replace them all. That's when I found out that some SA2000/2200 had the push/push tone knob to do coil splitting. Seems like mine never had that.. Everything looks stock on the guitar so I'm guessing it was one of the few without it. I am wondering if it is possible to setup the stock pickups for coil splitting or not. I'm curious as to why there is a soldering spot that is not connected.. so potentially this could be a 3-wire pickup? I'm mainly asking since I need to get 4 pots, I could get some push/pull to explore new pickup territories.

Below is what my current pickups look like... there appears to be an unconnected solder point where another wire could be connected but I'm guessing converting this would be much more involved and I question if worthwhile vs getting some new pickups.

[ATTACH=CONFIG]49987[/ATTACH]